Most Recent Story

Thermoplastic Pipe Expansion

Swimming pool piping is design is notorious for including long straight runs of pipe.  For pools that do include long runs of straight pipe sections, consideration may be given to the use of expansion loops or mechanical expansion joints to accommodate thermal expansion and contraction.  The ASTM Standard 2774 references “Underground Installation of Thermoplastic Pressure Piping”. This ASTM Standard 2774 contains specific information on the topic of expansion in pool piping.  Expansion and contraction of thermoplastic pipe is typically due to temperature changes to either the surrounding pipe embedment materials or changes in the pool water traveling in the pipe system. When temperature changes of the thermoplastic pipe does occur, changes to the piping network in the form of elongation or contraction will occur.  Therefore, in piping networks where there may exist sections of the pipe that are straight and without bends, expansion and contraction of the pipe can cause failures in the system.  Swimming pool piping networks that include PVC pipe used in straight runs nearing 100 LF should take special consideration to the potential expansion and contraction of the pool pipe.  In these instances the design of the pool piping system should have the coefficient of expansion calculated for determination if design accommodations for the expansion and contraction should be included.

In cases where expansion and contraction will be significant, inclusion of an expansion loop or even a mechanical expansion joint can be installed.  A pipe loop is a relatively easy item to include within the piping network.   This pipe loop, or offset, can alleviate the bending stresses that can occur when thermoplastic piping systems experience expansion and contraction.  If expansion joints are required, a detail for the expansion loop may include a specific dimension for the offset lengths.  Mechanical expansion joints work like a piston allowing the pipe to elongate or contract within the pipe run.  The installation of mechanical expansion and contraction joints is critical, particularly cleaning debris (sand, rock, dirt) out of the moving parts.  If small particles come in contact with the mechanical joint mechanism the joints seal can become compromised.

In most instances a linear pipe runs without interruption of bends, joints or pipe size changes is not common.  However, in situations where conditions do allow long pipe runs, your design should pay special attention for need of expansion and contraction loops and mechanical joints.

All Stories

Expansion and Contraction in PVC Pool Piping

In the commercial swimming pool industry, the overwhelming choice for pool piping material selection is Polyvinyl Chloride (PVC). The use of such materials can provide security, as it is non-corrosive, and if installed properly, some would say this pipe material can provide an almost infinite life span. But, in comparison to other pipe material selections, […]

Starting Blocks and Water Depth: Is Your Pool Safe?

When it comes to the world of competitive swimming, there are stringent guidelines that everyone involved in the pool design process must take into consideration. This is especially true for water depths beneath starting blocks. Starting blocks are raised platforms typically mounted on the pool deck at the end of competitive swimming lanes. In most […]

What are common concerns and options for winterizing a commercial swimming pool?

Winterizing a seasonal outdoor pool can vary greatly depending upon location, pool type, groundwater conditions, local sewer capacities and a host of other factors. If an outdoor swimming pool is not properly winterized, catastrophic damage to below grade piping, heaving and floating of the pool tank, undue wear on pool mechanical equipment, delamination of finishes […]

FILTRATION: High Rate Sand Vs. Regenerative Media

Until the past 5-10 years, pressure high rate sand filtration was installed on the majority of commercial pool applications.  There were and continue to be other types of filtration such as vacuum sand filters, cartridge filters, diatomaceous earth filters, and others.  But often whether it was due to the type of pool, cost, material handling, […]